Alphacool Eisbaer Refill Kit

In this kit you will find everything you need to fill your Eisbaer. The charging kit contains all the important tools you need to refill your Eisbaer CPU water cooling system in just a few simple steps. This includes a funnel with 1/4" thread, a high-quality thermal paste in a syringe, an adapter cable for the pump and an ATX jumper. Easy to use Remove the Eisbaer from your power supply making sure your power is cut off. Disconnect the 24-pin ATX connector from the motherboard and attach the ATX jumper plug to it. Place the radiator on a table and the Eisbaer CPU/Pump/Tank unit on a slightly raised surface. Then simply mount the funnel on the filling port. With the SATA to 3 pin adapter cable, you can now connect the Eisbaer's pump to your power supply. Now slowly fill the Eisbaer with your liquid until the tank is full. Now you can power back on. The ATX bridging plug starts the power supply and the pump of the Eisbaer starts working. It is important to turn off the pump from time to time to fill it with liquid. The pump should never run dry. When the Eisbaer is full, you can plug in the charging port again. Then let the Eisbaer come out a little outside your case, while you shake the Eisbaer in all directions. Ideally, always keep the radiator lower than the Eisbaer central unit/pump/tank so that the air can flow back into the tank. You will notice that you may need to stock up on liquid. The tank should be filled to about 90% at the end of the procedure. Comes with: 1 x ATX jumper connector, 1 x funnel

• Kit designed to allows customization of your AIO
• Includes ATX jumper plug
• Includes a funnel with G1/4" threads
• Includes SATA on 2 x 3-pin connector
• Includes thremal paste