JEGS Ignition Control Unit | Comparable to Mopar Orange Box | 5,000 RPM | Plugs Into All Mopar OEM and Performance Wiring Harnesses with 4 & 5 Pins

★★★★★ 4.2 133 Bewertungen

€16.58
Preis bei Onlinekauf
Kostenloser Versand 30 Tage kostenlose Rückgabe

Verkauft und versendet von www.mieruniszki.pl
Wir bemühen uns, Ihnen genaue Produktinformationen anzuzeigen. Hersteller, Lieferanten und andere stellen die hier gezeigten Angaben bereit.
€16.58
Preis bei Onlinekauf
Kostenloser Versand 30 Tage kostenlose Rückgabe

Wie möchten Sie Ihren Artikel erhalten?
Die ersten 30 Tage sind kostenlos! Wählen Sie den Tarif an der Kasse.
Versand
Ankunft 23.11.
Kostenlos
Abholung
In der Nähe prüfen
Lieferung
Nicht verfügbar

Verkauft und versendet von www.mieruniszki.pl
30 Tage kostenlose Rückgabe Details

Produktdetails

Artikelnummer 215276154 Erscheinungsdatum 2026/04/12 Listenpreis €16.58 Modellnummer 215276154
Kategorie

Orange Ignition Control UnitComparable to Mopar Orange Ignition Box5,000 RPM Installation Notes:Case must be grounded. Be sure mounting location (firewall, bracket, or fender apron) is free of rust & paint (sand or wire brush as required) before mounting Ignition Control Unit. Make sure the mounting screws are tight and use Serrated-head screws or external-tooth lock washers to mount the Ignition Control Unit. Coat connector pins with silicone grease. Be sure wiring connector retaining screw is present and snug.Plugs into all Mopar OEM, JEGS, and Mopar Performance wiring harnesses, whether the harness or vehicle was designed for 4 or 5-pin Ignition Control Units. No modifications required.Use with ballast resister. Works with 2-Pin or 4-Pin ballast resistors. Use without ballast resistor will destroy the Ignition Control Unit. Use with OEM or OEM-Spec (oil filled) ignition coil. E-Frame coils are also acceptable. High Performance Coil 555-40105 is also recommended. Coils made for C-D ignitions (MSD, etc) may destroy the Ignition Control Unit. Coil Primary resistance should be no lower than 1.4OPre-startup test (recommended for vehicles that has experienced Ignition Control Failure). Connect a voltmeter between the coil positive (+) and a good ground. Turn ignition key to "run" position. Voltmeter should read between 7.0 and 9.0 volts. If higher turn ignition key off immediately and check ballast resister (resistance - too low 0.5O minimum, 1.0O recommended for most street applications), ballast wiring, shorted coil, ignition switch wiring, etc.Quick Wiring Check - Disconnect either ballast connector at idle. Engine should stall instantly.

  • COMPARABLE TO Mopar orange ignition box
  • CONNECTS TO ALL Mopar OEM and performance wiring harnesses with both 4 and 5 pins
  • REPLACEMENT wiring harness and ballast resistor are available separately to repair or upgrade the ignition system
  • HIREV 7500 CONTROL UNIT option is also available separately
  • COMPATIBLE WITH OEM or aftermarket ignition coils with resistance no lower than 1.4 ohms
UPC 889944045991
Model 555-40800
Brand Name JEGS
Item Weight 16 ounces
Part Number 40800
Manufacturer JEGS
Material Type Silicone
Connector Type Screws
Item Dimensions 7.4 x 4.4 x 2.8 inches
Included Components Per Item Description
Warranty Description 30 Days
Part Interchange Info 40800

Korrektur der Produktinformationen

Wenn Sie Unvollständigkeiten oder Fehler in den Produktinformationen auf dieser Seite bemerken, nutzen Sie bitte das Korrekturformular unten.

Korrekturanfrage

Kundenbewertungen

4.2 von 5
★★★★★
133 Bewertungen | 55 Rezensionen
So wird die Artikelbewertung berechnet
Alle Bewertungen anzeigen
5 Sterne
78% (104)
4 Sterne
6% (8)
3 Sterne
3% (4)
2 Sterne
2% (3)
1 Stern
11% (15)
Sortieren nach

Für dieses Produkt liegen derzeit keine schriftlichen Bewertungen vor.